Pilote de moteur pas a pas A3967

Pilote de moteur pas a pas A3967

Code produit: A3967
Qté en Stock : 3
  • $6.49


Pour toutes questions sur les produits, vous pouvez nous rejoindre au (819) 373-4813 ou par courriel service@jcinfotr.com
Si vous avez besoin d'un item en grande quantité, contacté nous au (819) 373-4813 ou par courriel service@jcinfotr.com
Veiller prendre note que sur ces grandes commandes le prix peut varier.
  • Livraison Rapide
  • Paiment 100% sécurisé
  • Support par Téléphone ou Courriel
  • Pièces en magasin


Features


  • A3967 Microstepping Driver
  • MS1 and MS2 pins jumper out to change microstepping resolution to full, half, quarter and eighth steps (defaults to eighth)
  • Compatible with 4, 6, and 8 wire stepper motors of any voltage up to 30V
  • Adjustable current control from 150mA/phase to 700mA/phase
  • Power supply range for stepper motor from 6V to 30V. The higher the voltage, the higher the torque at high speeds


Step 1: Pin Definition

Step 2: Sample Hardware Connection


  • Here are the pin connections from Arduino Uno to Easy Driver :


D2 -- STEP
D3 --DIR
D4 -- MS1
D5 -- MS2
D6 -- ENABLE


  • and here are the pin connection from Stepper Motor to Easy Driver :


Green Wire -- A+
Red Wire -- A-
Blue Wire -- B+
Yellow Wire -- B-


  • For push button, just connect one of the button's pin to arduino's pin (D8, D9 or D10 refer to the picture) and the other button's pin connect to the ground.
  • To power up Easy Driver, the GND and +5v from Easy Driver are connected to the Arduino Uno's GND and +5v power pin.

  • The Motor Power Supply will be connected to the M+ and GND of the Easy Driver. Make sure to connect the battery's polarity is correct, positive to the M+ and negative to the GND.


Écrire une critique

Remarque: HTML n`est pas traduit!
    Mal           Bien
Captcha